Structure & Handling; Commissioning - MDT Push Button 55 Technical Manual

Technical Manual
Push-button 55 / Plus 55 [BE-TA55xx.x2]
2.4 Structure & Handling
The following pictures show the structure of the push-buttons (here using the example of BE-TA55P8.02):
Figure 2: Structure & Handling
1 = Bus connecting terminal
3 = Red programming LED
5 = Orientation-LED
(only Push-button Plus 55)

2.5 Commissioning

1. Wire the device according to the connection diagram.
2. Connect interface to the bus, e.g. MDT USB Interface.
3. Switch on bus voltage.
4. Press the programming button on the device (red programming LED lights up continuously).
5. Set and programme the individual address in the ETS. (Programming LED turns off)
6. Configure and programme the settings in the application programme.
MDT technologies GmbH · Papiermühle 1 · 51766 Engelskirchen · Germany
Phone +49 (0) 2263 880 · knx@mdt.de · www.mdt.de
2 = Programming button
4 = Operating buttons
6 = Status LEDs
(only Push-button Plus 55)
7 / 49