Recommended Scene; Set Fire And Smoke Detection - HIKVISION DS-2TD2637T-7/P User Manual

Thermal Optical Bi-spectrum Network Camera User Manual
The detection is applied to fire-prevention purposes in scenic region, forest, tunnel and so on. You
can configure the detection parameters. When fire source or smoke is detected, the alarm actions
will be triggered.
Note
Not all models support the function. Please take the actual product for reference.

7.2.1 Recommended Scene

This part introduces the recommended scenes of fire source detection and helps you select the
appropriate scene.
Fire source detection can be applied to indoor and outdoor monitoring with a large detection
radius. To achieve the best monitoring effect, please set the installation place as requirements
below.
The installation place should be the highest position within the detection area. The lens should
●
not be covered during movement to detect the maximum area.
It is better to choose the installation place with convenient traffic, well-equipped power and
●
internet facilities (e.g., communication tower, watchtower and high-rise roof).

7.2.2 Set Fire and Smoke Detection

To avoid the potential fire source and smoke damage simultaneously, you can configure the
function for certain areas. The detail configuration steps show as below.
Before You Start
Go to Configuration → System → Maintenance → VCA Resource Type , select Temperature
Measurement + Fire and Smoke Detection.
Steps
1. Go to Configuration → Event → Smart Event , select Fire and Smoke Detection.
2. Check Enable Fire and Smoke Detection.
3. Select Fire and Smoke Detection Mode.
Detection Mode
Fire or Smoke
Fire and Smoke
Mode Description
The system alarms when
device is triggered either by
Fire Source Detection or
Smoke Detection.
The system alarms when
device is triggered both by Fire
54
Configuration Description
Set Fire Source Detection and
Smoke Detection, see step 4.