HIKVISION DS-2TD2637T-7/P User Manual page 5

Thermal Optical Bi-spectrum Network Camera User Manual
These instructions are intended to ensure that user can use the product correctly to avoid danger
or property loss.
Laws and Regulations
In the use of the product, you must be in strict compliance with the electrical safety regulations
●
of the nation and region.
Transportation
Keep the device in original or similar packaging while transporting it.
●
Keep all wrappers after unpacking them for future use. In case of any failure occurred, you need
●
to return the device to the factory with the original wrapper. Transportation without the original
wrapper may result in damage on the device and the company shall not take any responsibilities.
DO NOT drop the product or subject it to physical shock. Keep the device away from magnetic
●
interference.
Power Supply
Check the input voltage before powering on the device to avoid damage.
●
CAUTION: If the fuse of the device can be replaced, replace it only with the same model to
●
reduce the risk of fire or electric shock.
If a fuse is connected to the neutral wire and a double pole/neutral fusing occurs, parts of the
●
device that remain energized might represent a hazard during servicing after operation of the
fuse.
If the device uses a 3-prong power supply plug, it must be connected to an earthed mains
●
socket-outlet properly.
Do not touch the bare components (such as the metal contacts of the inlets) and wait for at least
●
5 minutes, since electricity may still exist after the device is powered off.
For the permanently connected device without a disconnect equipment, a readily accessible
●
disconnect equipment shall be incorporated into the electrical installation of the connected
building.
For the permanently connected device without an overcurrent protection equipment, an
●
overcurrent protection equipment shall be incorporated into the electrical installation of the
connected building. The specifications of the overcurrent protection equipment shall not exceed
that of the building.
For the permanently connected device without an all-pole mains switch, an all-pole mains switch
●
shall be incorporated into the electrical installation of the connected building.
If the device is powered by terminals connected to the power cord, ensure correct voltage and
●
wiring of the terminals for connection to mains supply.
Safety Instruction
iv