Automatic Thermography - HIKVISION DS-2TD2637T-7/P User Manual

Thermal Optical Bi-spectrum Network Camera User Manual
Note
Please refer to the Quick Start Guide for detailed information of Installation part in the flow chart.

7.1.3 Automatic Thermography

Configure the temperature measurement parameters and temperature measurement rules. The
device can measure the actual temperature and output alarms when temperature exceeds the
alarm threshold value.
Set Thermography Parameters
Configure the parameters of temperature measurement.
Steps
1. Go to Configuration → Local , enable Display Temperature Info.
2. Click Save.
3. Go to Configuration → Temperature Measurement & Fire Prevention → Basic Settings to
configure parameters.
Enable Temperature Measurement
Check to enable temperature measurement function.
Enable Color-Temperature
Check to display Temperature-Color Ruler in live view.
Display Temperature Info. on Stream
Check to display temperature information on the stream.
Display Temperature in Optical Channel
Check to display thermal channel temperature information in the optical channel.
Display Max./Min./Average Temperature
Check to display maximum/minimum/average temperature information on liveview when the
temperature measurement rule is line or area.
Rule Name
Display the rule name rather than the rule ID on the live view. You can set the name in expert
temperature measurement mode for the rule.
Position of Thermometry Info
Select the position of temperature information showed on the live view.
Near Target: display the information beside the temperature measurement rule.
●
Top Left: display the information on the top left of screen.
●
Add Original Data on Capture
46