HIKVISION DS-2TD2637T-7/P User Manual page 67

Thermal Optical Bi-spectrum Network Camera User Manual
Note
The same parameters and linkage method apply to the two kinds of pre-alarm/alarm, only the
threshold temperature and arming schedule vary.
Offsite Pre-Alarm Temperature
When the temperature of target exceeds the Offsite Pre-Alarm Temperature during the
Offsite Arming Schedule, and this status lasts not shorter than the Filtering Time, the pre-
alarm is triggered.
Offsite Alarm Temperature
When the temperature of target exceeds the Offsite Alarm Temperature during the Offsite
Arming Schedule, and this status lasts not shorter than the Filtering Time, the alarm is
triggered.
Offsite Arming Schedule
Click and drag the time bar to select the arming off-hours for offsite pre-alarm and alarm.
8. Click Save.
Click Live View, and select thermal channel to view the temperature and rules information on
live view.
Point Thermography
Configure the temperature measurement rule and click any point in live view to monitor the
temperature.
Steps
1. Click in the live view and a cross cursor showed on the interface.
2. Drag the cross cursor to desired position.
Go to Live View interface to view the temperature and rule of the point in thermal channel.
Line Thermography
Configure the temperature measurement rule and monitor the maximum temperature of the line.
Steps
1. Click and drag the mouse to draw a line in the live view interface.
2. Click and move the line to adjust the position.
3. Click and drag the ends of the line to adjust the length.
Go to Live View interface to view the maximum temperature and rule of the line in thermal
channel.
52