Set Detection Shield Region - HIKVISION DS-2TD2637T-7/P User Manual

Thermal Optical Bi-spectrum Network Camera User Manual
Steps
1. Go to Configuration → Local .
2. Check Locate Highest Temperature Point to display the position of highest temperature. Check
Frame Fire Point to frame the fire source on live view.
3. Go to Configuration → Event → Smart Event , select Dynamic Fire Source Detection.
4. Check Enable Dynamic Fire Source Detection.
5. Set the parameters of fire detection.
Fire Source Detection
Smoking Mode
Detect smoking behavior in the scene.
Sensitivity
The sensitivity of fire detection. The bigger the value is, more easily the fire source can be
detected, and the false rate is higher.
Alarm Interval
Set the alarm interval between two alarms.
Picture Quality
Set picture quality as high, medium, or low.
Note
When VCA Resource Type is selected as Temperature Measurement + Perimeter Protection,
only Smoking Mode is supported in Fire Source Detection. When VCA Resource Type is selected
as Temperature Measurement + Fire and Smoke Detection, Dynamic Fire is also supported in
Fire Source Detection.
6. Check Display Fire Source Frame on Stream to display a red frame around the fire source on
stream when fire occurs.
7. Optional: Go to Smart Event → Fire Source Region Shield . You can shield certain areas from
being detected in fire source detection, refer to Set Detection Shield Region .
8. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for
setting linkage method.
9. Click Save.

7.2.4 Set Detection Shield Region

Steps
1. Go to Configuration → Local , and enable Display Shield Area.
2. Check to enable the function.
3. Click Draw Area and drag the mouse in the live view to draw the area. Release the mouse to
finish drawing. You can drag the corners of the red rectangle area to change its shape and size or
drag the rectangle to the position on your demand.
4. Click Stop Drawing. You can click Clear All to clear all of the setting areas.
57