HIKVISION DS-2TD2637T-7/P User Manual page 6

Thermal Optical Bi-spectrum Network Camera User Manual
Please purchase the charger by yourself. Input voltage should meet the Limited Power Source
●
(12 VDC, 24 VAC, or PoE(802.3af)) according to the IEC62368 standard. Please refer to technical
specifications for detailed information.
Make sure the plug is properly connected to the power socket.
●
The socket-outlet shall be installed near the equipment and shall be easily accessible.
●
DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards
●
caused by overload.
DO NOT touch the bare metal contacts of the inlets after the circuit breaker is turned off.
●
Electricity still exists.
+ identifies the positive terminal(s) of equipment which is used with, or generates direct current.
●
- identifies the negative terminal(s) of equipment which is used with, or generates direct current.
Battery
Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries
●
according to the instructions.
The built-in battery cannot be dismantled. Please contact the manufacture for repair if
●
necessary.
For long-term storage of the battery, make sure it is fully charged every half year to ensure the
●
battery quality. Otherwise, damage may occur.
This equipment is not suitable for use in locations where children are likely to be present.
●
Improper replacement of the battery with an incorrect type may defeat a safeguard (for
●
example, in the case of some lithium battery types).
DO NOT dispose of the battery into fire or a hot oven, or mechanically crush or cut the battery,
●
which may result in an explosion.
DO NOT leave the battery in an extremely high temperature surrounding environment, which
●
may result in an explosion or the leakage of flammable liquid or gas.
DO NOT subject the battery to extremely low air pressure, which may result in an explosion or
●
the leakage of flammable liquid or gas.
Installation
This device is suitable for use above 2 m only.
●
Install the device according to the instructions in Quick Start Guide. To prevent injury, this device
●
must be securely attached to the installation surface in accordance with the installation
instructions.
Never place the device in an unstable location. The device may fall, causing serious personal
●
injury or death.
The additional force shall be equal to three times the weight of the device but not less than 50
●
N. The device and its associated mounting means shall remain secure during the installation.
After the installation, the device, including any associated mounting plate, shall not be damaged.
Never place the equipment in an unstable location. The equipment may fall, causing serious
●
personal injury or death.
This equipment is for use only with corresponding brackets. Use with other (carts, stands, or
●
carriers) may result in instability causing injury.
v