Synchronize Time By Satellite; Set Ntp Server; Set Dst - HIKVISION DS-2DY7236IX-A User Manual

Network Speed Dome & Positioning System User Manual

11.10.2 Synchronize Time by Satellite

Note
This function varies depending on different devices.
Steps
1. Enter Configuration → System → System Settings → Time Settings.
2. Select Satellite Time Sync..
3. Set Interval.
4. Click Save.

11.10.3 Set NTP Server

You can use NTP server when accurate and reliable time source is required.
Before You Start
Set up a NTP server or obtain NTP server information.
Steps
1. Go to Configuration → System → System Settings → Time Settings.
2. Select Time Zone.
3. Click NTP.
4. Set Server Address, NTP Port and Interval.
Note
Server Address is NTP server IP address.
5. Click Test to test server connection.
6. Click Save.

11.10.4 Set DST

If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → System → System Settings → DST.
2. Check Enable DST.
3. Select Start Time, End Time and DST Bias.
4. Click Save.
91