Set Manual Dpc (Defective Pixel Correction); Set Picture In Picture - HIKVISION DS-2TD2637T-7/P User Manual

Thermal Optical Bi-spectrum Network Camera User Manual
Steps
1. Go to picture overlay setting page: Configuration → Image → Picture Overlay .
2. Select a channel to overlay picture.
3. Click Browse to select a picture, and click Upload.
The picture with a red rectangle will appear in live view after successfully uploading.
4. Check Enable Picture Overlay.
5. Drag the picture to adjust its position.
6. Click Save.

5.7 Set Manual DPC (Defective Pixel Correction)

If the amount of defective pixels in the image is comparatively small and accurate correction is
needed, you can correct these pixels manually.
Steps
1. Go to Configuration → Image → DPC .
2. Select the thermal channel.
3. Select manual mode.
4. Click the defective pixel on the image, then a cursor shows on the live view.
5. Click Up, Down, Left, Right to adjust the cursor position to the defective pixel position.
6. Click , then click
Note
If multiple defective pixels need to be corrected, click
●
after locating other pixels, click
This function is only supported by certain camera models.
●
7. Optional: Click

5.8 Set Picture in Picture

You can overlay the images of two channels and view the image of two channels at the same time.
Steps
1. Select a channel number.
2. Select the picture in picture mode.
Overlap Mode
Details Overlay
to correct defective pixel.
to correct them simultaneously.
to cancel defective pixel correction.
Partial image of thermal channel is displayed on the full screen of optical
channel. This mode is only supported in Camera 01.
The device displays the details of optical channel on thermal channel. This
mode is only supported in Camera 02.
after locating a defective pixel. Then
35