Set Region Exiting Detection - HIKVISION DS-2XC6285G0-L User Manual

Note
This function is only available for certain device models under certain settings. Please refer to
the actual settings.
Sensitivity
It stands for the percentage of the body part of an acceptable target that goes across the
predefined region. Sensitivity = 100 - S1/ST × 100. S1 stands for the target body part that goes
across the predefined region. ST stands for the complete target body. The higher the value of
sensitivity is, the more easily the alarm can be triggered.
Target Validity
If you set a higher validity, the required target features should be more obvious, and the
alarm accuracy would be higher. The target with less obvious features would be missing.
5. Optional: You can set the parameters of multiple areas by repeating the above steps.
6. For the arming schedule settings, refer to Set Arming Schedule . For the linkage method settings,
refer to Linkage Method Settings .
7. Click Save.

10.3.4 Set Region Exiting Detection

It is used to detect objects exiting from a predefined virtual region. If it occurs, the device can take
linkage actions.
Network Camera User Manual
Figure 10-3 Set Rule
80