Access To Device Via Pppoe Dial Up Connection; Snmp - HIKVISION DS-2XC6285G0-L User Manual

By Client Software Add domain name to the client software. Refer to the client manual for

8.3 Access to Device via PPPoE Dial Up Connection

This device supports the PPPoE auto dial-up function. The device gets a public IP address by ADSL
dial-up after the device is connected to a modem. You need to configure the PPPoE parameters of
the device.
Steps
1. Go to Configuration → Network → Network Settings → PPPoE .
2. Check Enable.
3. Set the PPPoE parameters.
Dynamic IP
After successful dial-up, the dynamic IP address of the WAN is displayed.
User Name
User name for dial-up network access.
Password
Password for dial-up network access.
Confirm
Input your dial-up password again.
4. Click Save.
5. Access the device.
By Browsers
By Client Software Add the WAN dynamic IP address to the client software. Refer to the
Note
The obtained IP address is dynamically assigned via PPPoE, so the IP address always changes
after rebooting the camera. To solve the inconvenience of the dynamic IP, you need to get a
domain name from the DDNS provider (e.g. DynDns.com). Refer to Access to Device via Domain
Name for detail information.

8.4 SNMP

You can set the SNMP network management protocol to get the alarm event and exception
messages in network transmission.
Network Camera User Manual
specific adding methods.
Enter the WAN dynamic IP address in the browser address bar to access
the device.
client manual for details.
50