Set Region Entrance Detection - HIKVISION DS-2XC6285G0-L User Manual

5. Optional: You can set the parameters of multiple areas by repeating the above steps.
6. For the arming schedule settings, refer to Set Arming Schedule . For the linkage method settings,
refer to Linkage Method Settings .
7. Click Save.

10.3.3 Set Region Entrance Detection

It is used to detect objects entering a predefined virtual region from the outside place. If it occurs,
the device can take linkage actions.
Before You Start
Go to VCA and select the application. Select Smart Event and click Next to enable the function.
●
For the device supporting HEOP, go to VCA to import and enable Smart Event.
●
Steps
1. Go to VCA → Set Application → Smart Event → Region Entrance Detection .
2. Check Enable.
3. Click Add to add a rule and set a detection area.
1) Draw a detection area. Click
boundaries of the detection area, and right click to complete drawing.
2) Set the minimum size and the maximum size for the target to improve detection accuracy.
Only targets whose size are between the maximum size and the minimum size trigger the
detection. Click
maximum target size.
3) Optional: Click
4. Set parameters.
Detection Target
This function allows alarm triggering by specified selected target types. If the detection target
is not selected, all the detected targets will be reported.
Network Camera User Manual
Figure 10-2 Set Rule
, click on the live view to specify the vertexes and draw the
and , then drag the mouse in the live view to draw the minimum and
to delete all the setting areas.
79