Set Rs-485; Set Live View Connection; Location Settings - HIKVISION DS-2XC6285G0-L User Manual

9.1.4 Set RS-485

RS-485 is used to connect the device to external device. You can use RS-485 to transmit the data
between the device and the computer or terminal when the communication distance is too long.
Before You Start
Connect the device and computer or terminal with RS-485 cable.
Steps
1. Go to Configuration → System → System Settings → RS-485 .
2. Set the RS-485 parameters.
Note
You should keep the parameters of the device and the computer or terminal all the same.
3. Click Save.

9.1.5 Set Live View Connection

It controls the remote live view connection amount.
Live view connection controls the maximum live view that can be streamed at the same time.
Enter Configuration → System → System Settings → System Service to set the upper limit of the
remote connection number.

9.1.6 Location Settings

Location displays and uploads the current longitude and latitude of the device.
Auto Uploading
Check Enable and set Location Upload Interval.
The device will upload its location at the set interval. You can also click Refresh to upgrade the
device location manually.
Manual Settings
Check Enable and set Location Upload Interval. Enter the longitude and latitude of the device
and click Save.
The device will upload the set location at the set interval.
Note
This function may vary according to different device models.
Network Camera User Manual
64