Set Ieee 802.1X; Set Qos - HIKVISION DS-2XC6285G0-L User Manual

Before You Start
Before setting the SNMP, you should download the SNMP software and manage to receive the
device information via SNMP port.
Steps
1. Go to Configuration → Network → Network Settings → SNMP .
2. Check Enable SNMPv1, Enable SNMP v2c or Enable SNMPv3.
Note
The SNMP version you select should be the same as that of the SNMP software.
And you also need to use the different version according to the security level required. SNMP v1
is not secure and SNMP v2 requires password for access. And SNMP v3 provides encryption and
if you use the third version, HTTPS protocol must be enabled.
3. Configure the SNMP settings.
4. Click Save.

8.5 Set IEEE 802.1X

You can authenticate user permission of the connected device by setting IEEE 802.1X.
Go to Configuration → Network → Network Settings → 802.1X , and enable the function.
Select protocol and version according to router information. User name and password of server are
required.
Note
If you set the Protocol to EAP-TLS, select the Client Certificate and CA Certificate.
●
If the function is abnormal, check if the selected certificate is abnormal in Certificate
●
Management.

8.6 Set QoS

QoS (Quality of Service) can help improve the network delay and network congestion by setting
the priority of data sending.
Note
QoS needs support from network device such as router and switch.
Steps
1. Go to Configuration → Network → Network Settings → QoS .
2. Set Video/Audio DSCP, Event/Alarm DSCP and Management DSCP.
Network Camera User Manual
51