Set Rs-232 - HIKVISION DS-2XC6285G0-L User Manual

Network Camera User Manual
3. Click NTP.
4. Set Server Address, NTP Port and Interval.
Note
Server Address is NTP server IP address.
5. Click Test to test server connection.
6. Click Save.
Synchronize Time by Satellite
Note
This function varies depending on different devices.
Steps
1. Enter Configuration → System → System Settings → Time Settings .
2. Select Satellite Time Sync..
3. Set Interval.
4. Click Save.
Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
function.
Steps
1. Go to Configuration → System → System Settings → Time Settings .
2. Check Enable.
3. Select Start Time, End Time and DST Bias.
4. Click Save.

9.1.3 Set RS-232

RS-232 can be used to debug device or access peripheral device. RS-232 can realize communication
between the device and computer or terminal when the communication distance is short.
Before You Start
Connect the device to computer or terminal with RS-232 cable.
Steps
1. Go to Configuration → System → System Settings → RS-232 .
2. Set RS-232 parameters to match the device with computer or terminal.
3. Click Save.
63