Set Qos; Set Ieee 802.1X - HIKVISION DS-2TD4668-35A4/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
5. Import certificate to the device.
- Select Signed certificate is available, start the installation directly. Click Browse and Install to
import the certificate to the device.
- Select Create the certificate request first and continue the installation. Click Browse and
Install to import the certificate to the device.
6. Click Save.

13.13.7 Set QoS

QoS (Quality of Service) can help improve the network delay and network congestion by setting
the priority of data sending.
Note
QoS needs support from network device such as router and switch.
Steps
1. Go to Configuration → Network → Advanced Configuration → QoS .
2. Set Video/Audio DSCP, Alarm DSCP and Management DSCP.
Note
Network can identify the priority of data transmission. The bigger the DSCP value is, the higher
the priority is. You need to set the same value in router while configuration.
3. Click Save.

13.13.8 Set IEEE 802.1X

IEEE 802.1x is a port-based network access control. It enhances the security level of the LAN/
WLAN. When devices connect to the network with IEEE 802.1x standard, the authentication is
needed.
Go to Configuration → Network → Advanced Settings → 802.1X , and enable the function.
Set Protocol and EAPOL Version according to router information.
Protocol
EAP-TLS and EAP-MD5 are selectable
EAP-MD5
If you use EAP-MD5, the authentication server must be configured. Register a user name and
password for 802.1X in the server in advance. Input the user name and password for
authentication.
EAP-TLS
If you use EAP-TLS, input Identify, Private Key Password, and upload CA Certificate, User
Certificate and Private Key.
94