Installing The Batteries; Using The Remote Control; Connections; Connections To A Terrestrial Antenna - Strong SRT 8221 User Manual

Digital hd combo receiver

Table of Contents

30. TIMER

2.5 Installing the batteries

Open the cover on the remote control and insert 2x AAA type batteries into the compartment.

Observe correct polarity of the batteries when inserting. A terminal diagram is shown inside the

compartment.

1. Remove the cover.

2. Insert the batteries.

3. Place the cover.

To use the remote control, point it towards the front of your receiver. The remote control supports a

range of up to 5 meters distance to the receiver at an angle of up to approx. 30 degrees.

NOTE:

3.1.1 Connecting to a terrestrial antenna

To receive broadcast signal, your terrestrial indoor or outdoor antenna must be connected to the

ANT IN connector on the back of the receiver. Use a properly shielded antenna cable and suitable

connectors.

3.1.2 Connecting to TV with HDMI cable

The TV set shall be connected with the receiver using a good quality HDMI cable. This connection

gives the highest possible quality.

3.1.3 Connecting to TV with SCART cable

The unit is also equipped with a SCART connector; alternatively, the TV set can be connected to the

receiver using a good quality SCART cable.

See an overview and/or edit the timer schedule

Managing the receiver will be limited or not possible if there are obstacles

between the remote control sensor (at the front panel of the receiver)

and the remote control. Direct sunlight or very bright light can reduce or

disturb the reception of the remote control signals.

Fig. 4

Fig. 5

Fig. 6

Table of Contents