Network Settings; Enable Tcp/Ip; Enable Netware - Sharp MX-5500N User Manual

Network Settings

Network settings are described below. Touch the [Network Settings] key to configure the settings.
When any of these settings are changed, you must exit the system settings, turn off the [POWER] key (
interval, and then turn the [POWER] key (
IP Address Setting
When using the machine on a TCP/IP network, use this
setting to configure the IP address of the machine.
The settings are shown below.
IP Address
Enter the IP address of the machine.
IP Subnet Mask
Entry the IP Subnet Mask.
IP Gateway
Enter the IP Gateway address.
DHCP
Use this setting to have the IP address obtained
automatically using DHCP (Dynamic Host Configuration
Protocol). When this setting is enabled, it is not
necessary to manually enter an IP address.
• If the machine will be used on a TCP/IP network, be
sure to enable

"Enable TCP/IP

• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, printing will not be possible.
Enable TCP/IP
To use the machine on a TCP/IP network, this setting
must be enabled. The IP address of the machine must
also be configured using

Enable NetWare

To use the machine on a NetWare network, this setting
must be enabled.
" below.
"IP Address Setting".
) back on to make the new settings take effect.
Enable EtherTalk
To use the machine on an EtherTalk network, this
setting must be enabled.
Enable NetBEUI
To use the machine on a NetBEUI network, this setting
must be enabled.
Reset the NIC
This returns all "Network Settings" to the factory default
settings.
Ping Command
Use this function to check if the machine can
communicate with a computer on the network.
Specify the IP address of the desired computer and
touch the [Execute] key. A message will appear
indicating whether or not the computer responded.
69
), wait a brief