Table of Contents
Advertisement
Function
Code
Hex
Remarks
5. If n1 and n2 are out of a defined area, this command is
ignored.
6. If n2 is within the defined area, registration does not
follow any particular order.
7. The following commands are not cleared.
a. Printer initialization (ESC @).
b. Print data cancel and command initialization (CAN).
c. Printer reset (ESC ? LF NULL).
Prints a logo pattern
<ESC> "9" n1 n2
1B 39 n1 n2
1. This command prints the logo pattern.
2. n1 specifies the starting block of the logo pattern.
3. n2 specifies the stopping block of the logo pattern.
Block No. 1
Block No. N-1
Block No. N
4. This is valid only when the line header is input.
5. When the starting block (n1) > stopping block (n2), this
command is ignored.
– 59 –
Start Block (n1)
Start Block (n2)
Advertisement
Table of Contents
