Table of Contents
Advertisement
ITF:
The value of k is optional and the maximum value also
differs according to the modes (40 digits maximum in
mode 4). If the data is a number of an odd digit, 0 is
automatically added at the beginning of the data.
CODE 128:
The value of k is optional and the maximum value also
differs according to the modes and the types of char-
acter number (51 digits maximum in mode 1). The
check character is automatically added.
CODE 93:
The value of k is optional and the maximum value also
differs according to the modes and the types of char-
acter (30 digits maximum in mode 1). The check
characters (C and K) are automatically added.
NW-7:
The value of k is optional, and the maximum value also
differs according to the modes and the types of char-
acter number (29 digits maximum in mode 7). The
start/stop code is also contained in the data (it is not
automatically added).
The bar code printing start position is at the upper end of
the current line. If the bar code is positioned beyond the
right margin, neither the bar code nor the character below
the bar code will be printed.
Data of CODE 128 and CODE 93
When <LF> is used in a command, some kinds of
control code cannot be sent by the host PC. The
control code should be sent as the data as shown
below.
When sending the following data, express as a set of
two characters.
Express "% (25H)" as "%0 (25H30H)"
Add "40H-5FH" after "%" for the control codes (00H -
1FH).
Express the control code (7FH) as "%5 (25H35H)."
Add "1-4 (31H - 34H)" after "%" for the function code.
Add "6-8 (36H - 38H)" after "%" for the start code.
– 14 –
Advertisement
Table of Contents
