Star Micronics TSP2000 Programmer's Manual page 15

n2: Designates printing characters below bar code or a
line feed.
n2 Action
1 Does not print characters below the bar code. Line
feed occurs after execution of the command.
2 Prints characters below the bar code. Line feed
occurs after execution of the command.
3 Does not print characters below the bar code. Line
feed does not occur afte execution of the command.
4 Prints characters below the var code. Line feed does
not occur after execution of the command.
The value of n2 can be set to 1 (01H) to 40 (04H) or "1" (31
H) to "4" (34H).
n3: Designates the mode. The width of the minimum
module is determined.
n3 Multi Level
1 2 Dots
2 3 Dots
3 4 Dots
4 — —
5 — —
6 — —
7 — —
8 — —
9 — —
The value of n3 can be set to 1 (01H) to 9 (09H) or to "1"
(31 H) to "9" (39H). can be set.
Note: Numbers in parenthesis indicate the number of
dots for bold patterns.
Note: Multi Level indicate the following bar codes.
a UPC-E
b UPC-A
– 12 –
Code 39, NW-7
2 Dots (6)
3 Dots (9)
4 Dots (12)
2 Dots (5)
3 Dots (8)
4 Dots (10)
2 Dots (4)
3 Dots (6)
4 Dots (8)
c JAN/EAN-8
d JAN/EAN-13
ITF
2 Dots (6)
4 Dots (9)
6 Dots (12)
2 Dots (6)
4 Dots (9)
6 Dots (12)
2 Dots (6)
4 Dots (9)
6 Dots (12)
e CODE 128
f CODE 93