Table of Contents
Advertisement
Function
Code
Hex
Remarks
Commands to Control Auto Cutter
Function
Code
Hex
Remarks
Control peripheral device #2 immediately
<SUB>
1A
1. Drives peripheral device 2.
2. Energizing time is 200 (ms); Delay time is 200 (ms).
3. This command is executed as soon as it is received.
4. This is not executed until the drive for peripheral
device 2 is completed.
Partial-cut command to the auto cutter.
<ESC> "d" n
1B 64 n
1. The value of n defines the cut operation.
n
Action
0
Partial Action
1
Partial Cut Action
2
Feed paper to the cutting position and perform a
partial action.
3
Feed paper to the cutting position and perform a
partial cut.
2. Parameter settings outside of the range ignores 3
bytes including the ESC code.
3. There are approximately 24 mm from the printing head
to the cutting position.
– 53 –
Advertisement
Table of Contents
