Table of Contents
Advertisement
Function
Code
Hex
Remarks
Function
Code
Hex
Remarks
Control peripheral device #1 immediately
<FS>
1CH
1. Drives the peripheral devices using the conditions
set by the pulse width for drive of the peripheral
device 1 (ESC BEL n1 n2 ).
2. The following describes the difference to Control
peripheral device #1 (BEL).
a. The printer will execute this command when it has
been received, while the Control peripheral device
#1 (BEL) stores the command in the data buffer just
as it does with other control codes and executes
them in the order they were received.
3. This is not executed until the drive for peripheral
device 2 is completed.
Control peripheral device #2 immediately
<EM>
19
1. Drives peripheral device 2.
2. Energizing time is 200 (ms); Delay time is 200 (ms).
3. This command is executed as soon as it is received.
4. This is not executed until the drive for peripheral
device 2 is completed.
– 52 –
Advertisement
Table of Contents
