Star Micronics TSP2000 Programmer's Manual page 30

Commands to Move the Print Position
Function
Code
Hex
Remarks
Function
Code
Hex
Remarks
Function
Code
Hex
Remarks
Line feed
<LF>
0A
Prints the data in the line buffer and feeds paper one line.
1. If there is no data prior to this code, only one line of
paper is feed.
2. Printing position is the left margin position.
Feed paper n lines
<ESC> "a" n
1BH, 61H, n
Feeds paper n lines when there is no data prior to this
code.
Form feed
<FF>
0C
Feeds paper to the top of the next page after printing the
data in the line buffer when the memory switch 1-2 is set
to 0.
Paper is fed back to its original position after a full cut of
the paper when the memory switch 1-2 is set ot 1.
1. The following action occurs when DIP switch 2-2 is set.
ON Feed to the top of the next page after printing.
OFF Cut paper after feeding approximately 24 mm.
– 27 –