Table of Contents
Advertisement
n4: Designates the height of the bar code. If the bar
code is higher than the amount for the line feed, the
amount of the line feed will automatically be ad-
justed.
Precautions
1. The starting position of the bar code is above the
current line.
2. If the bar code exceeds the right edge, characters
below the bar will not be printed.
3. You can combine characters and bit images.
4. If the height of the bar code (n4) is higher than the
amount for the line feed, that amount for the line feed
will be L x a. (L = n4/n rounded values.)
a:
Line feed pitch (Dot lines)
n:
Maximum expansion rate of characters (1 to 6)
n4: Maximum height of the bar code. (1 to 255)
5. When characters and bar codes are being used
together, the larger of n x a and L x a will be used for
the amount of line feed.
d1...dk: Bar code data
UPC-E/UPC-A: K = 11 (or 12)
The check digit at the 12th digit is automatically added,
and ignored even if it is specified.
JAN/EAN-8: K = 7 (or 8)
The check digit at the 8th digit is automatically added,
and ignored even if it is specified.
JAN/EAN-13: K = 12 (or 13)
The check digit at the 13th digit is automatically added,
and ignored even if it is specified.
CODE 39:
The value of k is optional and the maximum value also
differs according to the modes (21 digits maximum in
mode 7). The start/stop code ("*") is automatically
added.
– 13 –
Advertisement
Table of Contents
