Toyota 1C Repair Manual page 214

CHARGI NG SYSTIM - Alternator
CH-13
2 . ASSEMBLE RECTIFIER END FRAME AND RECTIFIER
HOLDER
(al Place the two insula_ t ors on the positi ve side studs.
lb) Place the two collars on the negative side studs .
(cl Install the rectifier end frame on the rectifie r holder.
Check that the wires are not touching the case.
(di Place the two insulators on the positive side studs.
(el Install the four nuts and condenso r on the studs .
(fl
Install the two rubber
caps
on the positive side studs.
3.
INSTALL ROTOR TO DRIVE END FRAME
(a) Slide the thin spacer collar on the rotor shaft w ith the
cup side facing the rotor .
(b)
Using a press install the drive end frame together
with the thick spacer collar.
4 . INSTALL FAN AND PULLEY
(a) Mount the rotor in a soft jaw vise.
(b) Slide the fan, pulley and spring washer on the rotor
shaft.
(cl Install and torque the nut.
Torque : 900 kg-cm (65 ft-lb, 88 N·m)
5. ASSEMBLE DRIVE END FRAME AND RECTIFI ER END
FRAME
(a) Install the drive end frame and rectifie r end frame
with the three through bolts .
(b) Make sure the rotor rotates smoothly.