Toyota 1C Repair Manual page 176

LU-1 0
FR
Vehicles
FF
Vehicles
FR
Vehic les
FF Vehicles
LUBRICATION SYSTEM -
011
Pu111 1 1
No. 102 Seal Packing
No. 102 Seal Packing
wone
lU0327
No. 102 Seal Packing
No.
102 Seal Packing
LUOUt
.....
2. INSTA LL OIL ST RAIN I R
Install the strainer with the two bolt,, two nuts and a new
gasket
Torqu e: Bolt 185 k9-cm {13 ft• lb. 18 N·m)
Nut 55 k9 -cm (48 ln.•lb, 5.4 N·m)
3. INSTAU NO. 2 OIL PAN
(a) Remove any old packing material and be careful
not
to drop any oil on the contacting surfaces of the No.
2
oil pan and cylindet" block.
• Using a razor blade and gasket scraper remo ve all the
old packin g (FIPG) material from the gasket surfaces
and
sealing
groove.
• Thoroughly clean all components to remove all the
loose material.
• Clean both sealing surfaces with
a
non-residue solvent
CAU TI ON: Do not use a solvent which will have
adverse affect on the painted surfaces.
(b)
Apply No. 102 seal packing (Part No. 08826-00080)
o r equivalent to the No. 2 oil pan
as shown in the
figure. ·
• Install a nozzle that has been cul to the 5 mm (0.20in.)
opening.
NOTE: Avoid applying an excess amount to the surface.
Be especially careful near oil passages.
• Parts must
be
assembled within 1 5 minutes of applica-
tion . Otherwise, the material must be removed and
reapplied.
• Immediately remove nozzle from tube and reinstall cap.
(c) Install the No. 2 oil pan with seven bolts.
Torque : 75 kg -cm (65 in.-lb. 7.4 N ·m )
4. INST ALL NO. 1 OIL PAN
5.
6.
7.
8.
9.
10 .
(a) Install the No. 1 oil pan in the same procedure of step
3.
(b)
Install the bol ts and nuts.
Torque : 75 kg -cm (65 in.-l b, 7.4 N·m)
INSTALL CRANK SHAFT TIMING PULLEY ANO NO. 2
IDLER PULLEY
(See steps 1 and 3 on page EM -32I
IN STA LL TIMING BELT
(See steps 7 to 20 on pages EM-33 to 37)
LOWER ENGINE
REFILL WITH ENGINE OIL
(See step 3 on page LU-4 )
START ENGINE AND CHECK FOR LEAKS
RECHECK OIL LEVEL