Toyota 1C Repair Manual page 197

STARTING SYSTEM - Starter
2. PERFORM HOLD-IN COIL OPEN CIRCUIT TEST
Using am ohmmeter, check for continuity -between ter-
minal 50 and the switch body.
If there is no continuity, replace the magnetic switch.
ASSEMBLY OF STARTER
(See page ST-11 or
121
NOTE: Use high-temperature grease to lubricate the
bearings and gears when assembling the starte-r.
1. PLACE ARMATURE INTO FIELD FRAME
Apply grease to the armature bearings and insert the
armature into the field frame .
2.
INSTALL BRUSH HOLDER AND BRUSHES
{a) Place the brush holder over the field frame .
(b) (2.0 kW)
Align the tab on the holder with the notch in the field
frame.
(c) Using a screw driver, hold the brush spring back and
install the brush into the brush holder. Install four
brushes.
NOTE: Make sure that
the
positive lead wires are not
grounded .