Toyota 1C Repair Manual page 151

-
FU-52
FUEL SYSTEM - Injection Pump
INSTALLATION OF INJECTION
PUMP
(See page FU-12)
1. INSTALL FUEL INLET
PIPE
TO INJECTION
PUMP
2 .
INSTALL INJECTION
PUMP REAR BRACKET
3. IN STALL INJECTION PUMP
la) Align the matc hmarks on the injection pump and
water pump .
lb)
Temporarily instal the mount bolt and nuts.
NOTE: Torque the mount bolt and nut to specification
after adjusting the injection timing.
4 . INSTALL INJECTION PUMP DRIVE PULLEY
(See steps 4, 7 to 19 on pages EM-32 to 37)
5 . INSPECT AND ADJUST INJECTION TIMING
(See page
EM-2 0)
6. INSTALL FOUR INJECTION PIPES
{See steps 5 and 8 on pages FU-10 and 11)
7. INSTALL
HEATER
PIPE MOUNTING BOLT AND NUT
(FF Vehicles)
8. CONNECT FOLLOWING HOSES :
la) A/ C or heater idle-up vacuum hose
lb) Boost compensator hose {CV)
{cl
No. 1 and No. 2 water by-pass hoses
(di Fuel inlet and outle t hoses
9. CONNECT FUEL CUT SOLENOID CONNECTOR
10. CONNECT THROTTLE CABLE TO INJECTION
PUMP (w/ AT)
11 . CONNECT ACCELERATOR CABLE TO INJECTION
PUMP
12. FILL WITH COOLAN T {See step 3 on page C0-3)