Table of Contents
Advertisement
Compatible SFP transceivers
For more information about which SFP transceivers are compatible with the
RUGGEDCOM RST2428P, as well as instructions for ordering and installation/
removal, refer to the
support.industry.siemens.com/cs/ww/en/ps/29634/man].
Note
Only use SFP transceivers approved by Siemens for RUGGEDCOM products. Siemens
accepts no liability as a result of performance issues related in whole or in part to
third-party components.
Installation/removal
For instructions on how to install and remove SFP transceivers, refer
to the
support.industry.siemens.com/cs/ww/en/ps/29634/man].
Replacement/exchange during operation
SINEC OS supports replacing and exchanging SFP transceivers while the device is in
operation.
After you have replaced an SFP transceiver with another SFP transceiver of the same
or a different type, the new SFP transceiver is automatically configured in such a
way that it works in the same operating state as the previous SFP transceiver.
When replacing a plug-in transceiver, the parts of the configuration that are not
suitable for the new plug-in transceiver (e.g. autonegotiation) are reset to their
default settings.
3.3
PoE Ports
The device supports up to twenty-four 10/100/1000 Mbps Power over Ethernet
(PoE) ports powered by an external power supply. Each port complies with the IEEE
802.3af, IEEE 802.3at, and IEEE 802.3ab standards. Ports also feature auto-sensing
and automatic power off when cables are removed.
The total allowable power budget for all ports is 500 W. If the external power supply
is less than the PoE power demand, to prevent exceeding the power budget, port
priorities can be set via the RUGGEDCOM SINEC OS operating system to disable low
priority ports when demand is too high. Ports can also be enabled/disabled and
placed on a power schedule to conserve power. For more information, refer to the
associated
cs/ww/en/ps/29634/man]
For information about connecting the external power supply, refer to "Connecting
external PoE power" (Page 41).
RUGGEDCOM RST2428P
Equipment Manual, 10/2023, C79000-G8976-1528-01
"RUGGEDCOM SFP Transceivers Reference Manual" [https://
"RUGGEDCOM SFP Transceivers Reference Manual" [https://
NOTICE
"SINEC OS Configuration Manuals" [https://support.industry.siemens.com/
associated with the installed software release.
Communication ports
3.3 PoE Ports
53
Advertisement
Table of Contents
Need help?
Do you have a question about the SIMATIC NET RUGGEDCOM RST2428P and is the answer not in the manual?
Questions and answers