General Procedure - Siemens SIMATIC NET RUGGEDCOM RST2428P Equipment Manual

Installing the device
2.1 General procedure
Pollution degree
This device must be installed in an environment with a minimum pollution degree of
PD2.
Changes and modifications
This product contains no user-serviceable parts. Attempted service by unauthorized
personnel shall render all warranties null and void.
Changes or modifications not expressly approved by Siemens Canada Ltd. could
invalidate specifications, test results, and agency approvals, and void the user's
authority to operate the equipment.
Restricted access
This product should be installed in a restricted access location where access can only
be gained by authorized personnel who have been informed of the restrictions and
any precautions that must be taken. Access must only be possible through the use
of a tool, lock and key, or other means of security, and controlled by the authority
responsible for the location.
2.1

General procedure

The general procedure for installing the device is as follows:
User responsibility
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
20
NOTICE
NOTICE
NOTICE
NOTICE
Review the relevant certification information for any regulatory
requirements.
For more information, refer to "Approvals" (Page 67).
Review the "RUGGEDCOM Modules Reference Manual" for the device and
note any special installation or regulatory requirements related to the
installed modules.
Some modules may also operate at lower ambient temperatures than the overall
chassis.
RUGGEDCOM RST2428P
Equipment Manual, 10/2023, C79000-G8976-1528-01