Table of Contents
Advertisement
Communication Ports
4.2 PoE Ports
Electric shock hazard – risk of serious personal injury and/or equipment
interference
If shielded cables are used, make sure the shielded cables do not form a ground loop
via the shield wire and the RJ45 receptacles at either end. Ground loops can cause
excessive noise and interference, but more importantly, create a potential shock
hazard that can result in serious injury.
LEDs
Each port features a dedicated LED that indicates the state of the port.
Yellow (Solid)
Yellow (Blinking)
Off
Pin-Out
The following is the pin-out for the RJ45 male connectors:
8
Figure 4.2
Specifications
For specifications on the available copper Ethernet ports, refer to
Port Specifications" (Page
4.2
PoE Ports
The RUGGEDCOM RS416P supports up to four 10/100Base-TX Power over Ethernet
(POE) ports powered by an external power supply. Each port complies with the IEEE
802.3af standard and features auto-sensing and automatic power off when cables
are removed.
PoE ports can be located in sets of two in slots 5 and 6.
24
WARNING
State
1
RJ45 Ethernet Port Pin
Configuration
Link established
Transmitting/receiving
No link detected
34).
Description
Pin
Name
1
RX+
2
RX-
3
TX+
4
Reserved (Do Not Connect)
5
Reserved (Do Not Connect)
6
TX-
7
Reserved (Do Not Connect)
8
Reserved (Do Not Connect)
"Copper Ethernet
Installation Manual, 11/2022, C79000-G8976-1019-11
Description
Receive Data+
Receive Data-
Transmit Data+
Transmit Data-
RUGGEDCOM RS416P
Advertisement
Table of Contents
