Table of Contents
Advertisement
Communication Ports
4.2 PoE Ports
4.2
PoE Ports
The RUGGEDCOM RSG2100P comes standard with two 10/100Base-TX Power over
Ethernet (POE) ports powered by an external power supply. Each port complies with
the IEEE 802.3af standard and features auto-sensing and automatic power off when
cables are removed.
PoE ports are located in slots 9 and 10 .
The total allowable power budget for all ports is 60 W. If the external power supply is
less than 75 W, to prevent exceeding the power budget, port priorities can be set via
the RUGGEDCOM RSG2100P operating system to disable low priority ports when de-
mand is too high. Ports can also be enabled/disabled and placed on a power schedule
to conserve power. For more information, refer to the RUGGEDCOM RSG2100P User
Guide for the RUGGEDCOM RSG2100P.
For information about connecting the external power supply, refer to
External PoE Power (Page
LEDs
Each port features a dedicated LED that indicates the state of the port.
Yellow (Solid)
Yellow (Blinking)
Off
Pin-Out
The pin-out for the PoE ports is as follows:
8
Figure 4.5
Specifications
For specifications on the available PoE ports, refer to
tions (Page
26
16)".
State
1
RJ45 Ethernet Port PoE Pin
Configuration
33)".
Description
Link established
Transmitting/receiving
No link detected
Pin
1
2
3
4
5
6
7
8
"PoE Power Supply Specifica-
Installation Manual, 01/2020, C79000-G8976-1041-16
"Connecting
Description
RX + and Power -
RX - and Power -
TX + and Power +
Reserved (Do
Not Connect)
Reserved (Do
Not Connect)
TX - and Power +
Reserved (Do
Not Connect)
Reserved (Do
Not Connect)
RUGGEDCOM RSG2100P
Advertisement
Table of Contents
