Table of Contents
Advertisement
efesotomasyon.com -Toshiba inverter,drive,servo,plc
List of contact input terminal function settings
Parameter
programmed value
Positive
logic
7
*1: Active when (frequency setting mode selection) = (UP/DOWN from external logic input) is set.
The frequency setup range is from to (upper limit frequency). The acceleration/deceleration time
relative to the set frequency is / while the acceleration/deceleration speed is not switched.
☆ For details about the input terminal function, see 11.6.
Function
Negative
logic
No function
Forward run command
Reverse run command
Standby
Reset command
Preset-speed command 1
Preset-speed command 2
Preset-speed command 3
Preset-speed command 4
Jog run mode
Emergency stop by
external signal
DC braking command
2nd
acceleration/deceleration
2nd V/F control mode
switching
2nd stall prevention level
Parameter
programmed value
Positive
Negative
logic
logic
PID control prohibition
Forced local from communication
Operation hold (hold of 3-wire
operation)
PID integral/differential clear
PID characteristics switching
Frequency UP from external logic
input *1
Frequency DOWN from external
logic input *1
Frequency UP/DOWN from external
contacts *1
Coast stop
Frequency setting mode terminal
board VI
Command mode terminal board
Parameter editing permission
Forced deceleration command
Parameter editing prohibition
G-6
E6581595
Function
Advertisement
Table of Contents
