Toshiba VFNC3-2001P Instruction Manual page 112

efesotomasyon.com -Toshiba inverter,drive,servo,plc
6.3.3
 : Input terminal selection 1A (F)
 : Input terminal selection 2A (R)
 : Input terminal selection 3A (S1)
 : Input terminal selection 4A (S2)
 : Analog/logic input selection (VI
6
 : Input terminal selection 5 (VI)
⇒For details about input terminal functions, see 7.2.1.
6.3.4
 : Output terminal selection 1A (OUT-NO)
 : Output terminal selection 2 (FL)
 : Output terminal selection 1B (OUT-NO)
 : Output terminal logic selection (OUT-NO)
⇒For details about output terminal functions, see 7.2.2.
Explanation of the coast stop function
When ST (Standby) is OFF, coast stops.
The default setting for ST (Standby) is ON, change the
following settings.
= (no function)
Assign open input terminal 6: ST (Standby).
Coast stops if terminal set for ST (Standby) is set to
OFF. The monitor on the inverter at this time displays

Modifying input terminal functions
Terminal)
Modifying output terminal functions
Motor
speed
F-CC
ST-CC
 : Input terminal selection 1B (F)
 : Input terminal selection 2B (R)
 : Input terminal selection 3B (S1)
 : Input terminal selection 4B (S2)
 : Input terminal selection 1C (F)
 : Input terminal selection 2C (R)
F-8
E6581595
Coast stop
ON
OFF
ON
OFF