Table of Contents
Advertisement
efesotomasyon.com -Toshiba inverter,drive,servo,plc
Standard setting mode
4
For reasons of safety, the following parameters have been set up so that they cannot be reprogrammed while the
inverter is running.
［Basic parameters］
*(Command mode selection)
*(Frequency setting mode selection)
［Basic parameters］
/ (Always-active function selection
Analog/logic input selection (VI terminal)
to (Input terminal selection 1A to 5)
to (Output terminal selection 1A～1B)
(Output terminal logic selection(OUT-NO))
to (Input terminal selection 1B~2C)
* and can be changed during operation by setting =.
: The mode changes to the Standard setting mode when
the EASY key is pressed and "" is displayed.
Both basic and extended all parameters are displayed.
Basic parameters
Extended parameters : The parameters for detailed and special
(Guidance function)
(Automatic acceleration/deceleration)
(Torque boost setting macro function)
(Priority selection
(Both F and R are ON))
1/2)
(Sink/source switching)
(Factory specific coefficient 1A)
(Auto-restart control selection)
(Regenerative power ride-through control
(Deceleration stop))
(Overvoltage limit operation
(Slowdown stop mode selection))
(Supply voltage correction
(limitation of output voltage))
: This parameter is a basic parameter for the
operation of the inverter.
⇒ For details, refer to Section 5 in E6581595.
⇒ For parameter tables, refer to Section 11.
setting.
⇒ For details, refer to Section 6 in E6581595.
⇒ For parameter tables, refer to Section 11.
(Maximum frequency)
(V/F control mode selection)
(Default setting)
(Checking the region setting)
(Reverse-run prohibition)
(Carrier frequency control mode selection)
(PID control)
(Auto-tuning)
(Motor specific coefficient 2)
to (Motor specific coefficient 7 to 9)
(Emergency stop selection)
(Output phase failure detection mode selection)
(Input phase failure detection mode selection)
(Detection of output short-circuit during start-up)
(Undervoltage trip/alarm selection)
(Factory specific coefficient 6A)
(Logic output/pulse train output selection
(OUT-NO))
(Analog output signal selection)
D-4
E6581595
Advertisement
Table of Contents
