Cutting With An Angle; General Advice For The Cutting - Norton clipper TR 231 GL Operating Instructions Manual

VERS. 2015.07.13
Rotate both shafts by 90° to lock side extension

5.3 Cutting with an angle

You can cut from 0º to 45º by tilting the head rail. For this purpose:

Loosen the two knobs maintaining the head rail to tilt the head to the desired angle.

Retighten the two knobs.

5.4 General advice for the cutting


Only materials with max. dimensions of 1200x800x20mm and max. weight of 15kg can be cut
with the TR 231.

Before commencing work make sure tools are firmly seated!

Select the right tools as recommended by the manufacturer depending on the material to be
worked, the working procedure (dry or wet cut) to be carried out and the required efficiency.

Make sure the water pan contains enough water.
18
TR 231_MAN_EN