Winding The Hook Thread - Dürkopp Adler 513 Operating Instructions Manual

Operation
Operating Instructions 513/533 - 01.0 - 09/2023
3.4

Winding the hook thread

Fig. 4: Winding the hook thread
①
②
③
(1) - Thread clamp
(2) - Bobbin
(3) - Bobbin shaft
To wind the hook thread:
1. Fit the bobbin (2) on the bobbin shaft (3).
2. Pull the thread through the guide (5) and around the tensioner
element (6).
3. Wind the thread counterclockwise approx. 5 x around the
bobbin core (2).
4. Press the winder lever (4) into the bobbin.
5. Start sewing.
 The bobbin winder stops automatically when the configured
bobbin filling quantity has been reached.
6. Tear off the thread at the thread clamp (1) after winding.
If the thread must be wound without sewing, then the thread
winding mode can be set in the control ( p. 37).
⑤
④
(4) - Winder lever
(5) - Guide
(6) - Tensioner element
⑥
19