Dürkopp Adler 513 Operating Instructions Manual page 59

Programming
No.
U033 Set the number of stitches released by
the thread-pulling knife
U034 No delay at thread-pulling knife
U035 Thread-pulling knife
(if yes, parameters U002-U007 apply;
if no, parameters U010-U016 apply)
U036 Select the feed time.
If the stitches are not tightened prop-
erly, change the value towards "-".
U037 Sewing foot status at the end of
sewing
U038 If the sewing foot fails to lift, you can
only start sewing by using the pedal
U039 Look for initial stitch position at seam
end
U040 Look for origin during cyclical sewing
U041 Look for origin while sewing the seam
pattern
U042 Stop position of needle bar
Operating Instructions 513/533 - 01.0 - 09/2023
Function Value range
1 to 7 stitches
-10 to 0
0 = yes
1 = no
-8 to 16
0 = return to sewing
start, then lift
1 = return to sewing start
and lift at the same time
2 = lift sewing foot
manually by pressing
the pedal
0 = normal
1 = do not lift sewing foot
0 = do not look for origin
1 = look for origin
0 = do not look for origin
1 = look for origin at the
end of each seam pattern
2 = entire cycle ends
0 = do not look for origin
1 = look for origin
0 = upper position
1 = highest position
Unit Default
Stitches 2
- -5
- 1
- -8
- 1
- 0
- 0
- 0
- 0
- 0
57