Dürkopp Adler 513 Operating Instructions Manual page 109

Troubleshooting
Error Description
E-015 Beyond the
sewing area
E-016 Error upper
needle position
E-018 Cutting device
position error
E-019 Emergency stop
switch not at
regular position
E-020 Stepper motor
card software
version error
E-022 Machine stop
after aging
E-025 Search error
X-axis
E-026 Search error
Y-axis
E-027 Error
Clamping foot
search
E-028 Error
Thread-pulling
knife search
Operating Instructions 513/533 - 01.0 - 09/2023
Possible cause
The sewing area exceeds its
limits.
Needle bar is not in the upper
position.
The cutter is not at the correct
position.
Prior to the start of the machine,
the emergency stop switch
must be pressed down.
The software version for the
stepper motor card is wrong.
The machine stops after
entering into aging mode.
X-axis sensor not responding.
Y-axis sensor not responding.
Clamping foot sensor not
responding.
Thread-pulling knife sensor not
responding.
Troubleshooting
• Press the RESET switch to
confirm the pattern and its
X/Y scale rate.
• Triggering condition: Error
during the pattern calculation.
• Check the connections.
• Rotate the needle bar to the
top dead center.
• Switch off the power and
check the sensor for the knife
position.
• Solve the problem manually.
• Replace the stepper motor
card or update the software
for the stepper motor card.
• Switch the machine off.
• Main switch OFF.
• Check the sensor.
• Main switch OFF.
• Check the sensor.
• Main switch OFF.
• Check the sensor.
• Main switch OFF.
• Check the sensor.
107