Table of Contents
Advertisement
Front park lamps
1. Follow the steps described in section
Front lamps previously in this chapter
to gain access to the lamp assembly.
2. Remove the outboard low beam dust
cover to access the bulb.
Note Take care not to drop the dust
cap into the engine compartment.
3. Remove the park lamp bulb holder by
pulling it straight out.
4. Remove the park lamp bulb by pulling
it straight out of the holder.
5. Insert the new bulb into the holder,
then install the holder. Replace the
low beam bulb dust cap (ensuring the
rubber seal is in place).
6. Install components removed in step 1.
Refer to Front lamps previously in
this chapter.
7. Check lamp operation.
Front park lamps
1. Follow the steps described in section
Front lamps previously in this chapter
to gain access to the lamp assembly.
2. Remove the inboard high beam dust
cover to access the bulb.
Note Take care not to drop the dust
cap into the engine compartment.
3. Remove the high beam bulb to gain
access to the park lamp bulb, refer
to Headlamps – inboard high beam
previously in this chapter.
4. Remove the park lamp bulb holder by
pulling it straight out.
5. Remove the park lamp bulb by pulling
it straight out of the holder.
6. Insert the new bulb into the holder,
then install the holder. Install the high
beam bulb and dust cap (ensuring the
rubber seal is in place).
7. Install components removed in step 1.
Refer to Front lamps previously in
this chapter.
8. Check lamp operation.
BuLB REPLACEmEnT cont.
3
3
Chapter 6
EMERGENCIES
6-35
Advertisement
Table of Contents
