GMC VE UTE Series Owner's Handbook Manual page 153

8. The front edge of the cover has a
magnetic strip, ensure it is seated
down correctly.
9. Lay the tonneau cover over the bows.
10. Starting from the rear, use the finger
loops to pull the cover's plastic strip
over the slot provided around the top
edge of the load area.
11. Push down with your hands to smooth
the rear strip into place along the slot.
12. After the cover is attached at the rear,
the same attachment method is used
on both sides. Begin near the front
where finger loops are provided.
Note The cover may be tight to fit
when new.
SofT TonnEAu CoVER
Chapter 3
KNOW YOUR VEHICLE
3
cont.
3-25
VEUD3_084
VEUD3_072
VEUD3_071