Configuring Member Switches - Part I; Table 26: Configuring Member Switches - Part I - Allied Telesis x530 Series Installation Manual

Chapter 8: Building the Stack with Gigabit or 5G Multi-speed Ports
Configuring
Member Switches
- Part I
Step
1 Power on a member switch and start a local management session. Refer to "Starting
a Management Session" on page 138.
2 Enter the ENABLE and CONFIGURE TERMINAL commands to move to the Global
Configuration mode:
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
Step 3 sets the member switch's ID number.
3 Set the ID number of the member switch with the STACK RENUMBER command.
Each switch must have a unique ID number. The default value is 1. If you are using
the worksheet on "Stacking Worksheet" on page 87, refer there for the ID numbers.
This example changes the switch's ID number from the default value 1 to the new
value 2.
awplus(config)# stack 1 renumber 2
% Warning: the new ID will not become effective until the stack-
member reboots.
% Warning: the boot configuration may now be invalid.
The remaining steps reboot the unit. (You do not have to update the configuration file with the
WRITE command after changing a switch's ID number.)
4 Enter the EXIT command to return to the Privileged Exec mode.
awplus(config)# exit
164
4. Save your changes with the WRITE command in the Privilege Exec
mode.
5. Restart the switch with the REBOOT command.
6. Start a new local management session.
7. Verify your changes with the SHOW STACK and SHOW RUNNING-
CONFIG INTERFACE commands.
Perform Part I in Table 26 to configure a member switch.
Table 26. Configuring Member Switches - Part I
Description and Command