Placing Your Printer - Dascom Tally T2380 User Manual

Installation

Placing your printer

8
Do not expose the printer to direct sunlight. If you cannot avoid plac-
ing the printer near a window, protect it from the sunlight with a cur-
tain.
When connecting the computer with the printer, make sure not to ex-
ceed the permitted cable length
page 135).
Ensure sufficient distance between the printer and any heating radi-
ators.
2
1
0
Avoid exposing the printer to extreme temperature or air humidity
C
90
80
70
60
50 fluctuations. Above all take care to avoid the influence of dust.
40
30
20
10
0
-10
It is recommended to install the printer in a place which is acousti-
cally isolated from the workplace because of the noise it may
produce.
LŠrm.iso
Place the printer on a solid, flat, surface, ensuring
that the printer is positioned in such a way that it
can not topple, and that there is easy access to the
control panel and paper input devices. Also en-
sure that there is sufficient space for the printed
output.
If you expect that frequent forward and reverse
feeds will occur, you should place the printer as
shown in the figure, if possible.
The power supply cable may be dam-
STOP
aged if the paper edges constantly
chafe the insulating sheath. The user
must always ensure that there is suffi-
cient distance between the power sup-
ply cable and the paper.
When selecting the printer location, observe the
following additional instructions:
Never place the printer in the vicinity of
STOP
inflammable gas or explosive sub-
stances.
(see Interface specifications,
User guide