Model; Introduction; Rear Tractor Paper Path - Dascom Tally T2380 User Manual

User guide
8
2T model

Introduction

Rear tractor paper path

This section describes how to handle the rear tractor (paper feed
from the rear), which is only available and permanently installed in
the 2T printer model in addition to the primary tractor (paper feed
from the front).
The Paperway parameter group in the menu of the 2T model differs
from the one of the standard printer as follows:
Standard printer
Paperway
Tractor1 (standard, front)
Tractor2 (optional, front)
The permanently installed rear tractor is identified as "Trac3"
in the menu. "Trac2" in the menu refers to the optional tractor
which can be installed both on the standard printer and the 2T
model. The optional tractor 2 can be installed by the user.
Tractor 3
For information on the printable length and width of the forms
and other specifications, refer to
The 2T model cannot accommodate an additional automatic
single sheet feeder, which is available for some printer models.
2T printer
Paperway
Tractor1 (standard, front)
Tractor2 (optional, front)
Tractor3 (standard, rear)
Tractor 1
Paper specifications, page 136.
2T model
49