Menu Configurations - Dascom Tally T2380 User Manual

The Menu

Menu configurations

Online Trac1
Tear
1 2 3 4
Adjust Paperway
Menu Char
1 2 3 4
Print Menu
Back Next
1 2 3 4
Load Menu=1 *
Set < > Exit
1 2 3 4
56
Every printer is shipped with factory default settings. Basic settings
such as emulation, character size, form length etc., which many ap-
plications make use of, are set. At the end of this chapter you will find
a menu printout
tings.
Your printer allows you to set and use five independent menu con-
figurations. If one of your applications for example requires an IBM
printer while another program works better with an EPSON printer,
you can set an IBM emulation configuration with the desired set-
tings, and set the second configuration as an EPSON emulation.
The active menu is always the one you used last. When you switch
on the printer for the very first time, menu no. 1 is loaded. Menu no.
1 only remains active until you load another menu. The last active
menu is stored even after the printer is switched off and is reloaded
automatically when the printer is switched on again.
For example, to change from menu no. 1 to menu no. 3:
Press Setup key.
Online
Setup
Press Menu (1) key.
Online
Setup
Press Menu (3) key.
Online
Setup
Now the following message appears in the LC display:
Now press the < (2) or > (3) key repeatedly until Load Menu=3 ap-
pears.
Online
Then select menu no. 3 as the current setting using the Set key (1).
Setup
The currently active setting is marked with an asterisk (
If changing menues it is possible that the printer initializes due
to different emulation settings.
(page 93) which shows you the printer's default set-
User guide
).
*