Selecting Character Density And Font - Dascom Tally T2380 User Manual

Settings
Selecting character
density and font
Adjust Paperway
Menu Char
1 2 3 4
Font CPI
1 2 3 4
10 CPI *
Set < > Exit
1 2 3 4
ROMAN NLQ
Set < > Exit
1 2 3 4
Adjust Paperway
Menu Char
1 2 3 4
48
You can use the CPI (Character Per Inch) key in setup mode to se-
lect the number of characters per inch to be printed. You can use the
Font key to select resident fonts.
Press the Setup key, then the Char (4) key.
Online
Setup
Press the CPI (3) or Font (2) key (in our example, press CPI).
Online
Setup
Use the < (2) or > (3) key to set the desired character density. Con-
firm the selection by pressing the Set (1) key.
Online
You can cancel the selection and leave the setting unchanged by
Setup pressing the Exit (4) key.
If you pressed the Font (2) key, use the < (2) or > (3) key to select
the desired font. Confirm the selection by pressing the Set (1) key.
Online
You can cancel the selection and leave the setting unchanged by
Setup pressing the Exit (4) key.
Press the Setup key. The printer returns to the initial status.
Online It is also possible to press the Online key. The printer then changes
directly to online mode.
Setup
The selection made will not be retained after switching off the
printer. For more details on how to set the character density
and fonts permanently, please refer to the chapter
racter density (CPI) (page 64) and Selecting font (Font) (page
User guide
Setting cha-
63).