Selecting Emulation (Emulate); Bidirectional Printing (Bidir) - Dascom Tally T2380 User Manual

The Menu
Selecting emulation
(Emulate)
ESCChar Emulate
Back Next
1 2 3 4
Epson LQ-2550 *
Set < > Exit
1 2 3 4
Bidirectional printing
(Bidir)
Bidir I/O
Back Next
1 2 3 4
Bidir=On *
Set < > Exit
1 2 3 4
66
Selects the emulation. When a printer understands the control set
written for another printer type, it is said to emulate the other printer.
MTPL is also active in IBM or Epson emulation mode.
Press Emulate (3) key.
Online
Setup
Use the < (2) or > (3) key to select the desired setting.
Online
Setting Options: Epson LQ-2550, Epson LQ-2170,
Setup
Default Setting: Epson LQ-2550
You are using a sophisticated product. However you may find
additional or different emulations in this section depending on
the loaded firmware.
If the printer is switched to online mode after changing the emula-
tion, it performs a reset.
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
Setting On: Printer prints in both directions (bidirectional).
Setting Off: Printer prints only in one direction (from left to right).
Press Bidir (2) key.
Online
Setup
Use the < (2) or > (3) key to select the desired setting.
Online Setting Options: On/Off
Default Setting: On
Setup
Confirm the setting by pressing the Set key (1).
The setting On will not be overwritten by ESC sequences.
IBM Propr. XL24, IBM ProXL24+AGM,
MTPL, Genicom ANSI
User guide