Shut Down And Park - JLG 800S Operation & Safety Manual

2. Reconnect drive hubs by inverting disconnect cap.
3. Disconnect tow bar from steering hitch and from towing vehicle. The machine is
now in the driving mode.
*Chassis layout may vary depending on machine.

4.22 SHUT DOWN AND PARK

The preferred procedures to shut down and park the machine are as follows:
1. Drive machine to a reasonably well protected area.
2. Ensure boom is fully retracted and lowered over rear axle.
3. Shut down Emergency Stop at Platform Controls.
4. Shut down Emergency Stop at Ground Controls. Position Platform/Ground Select
switch to center OFF (center position).
5. If necessary, cover Platform Controls to protect instruction placards, warning
decals, and operating controls from hostile environment.
800S, 860SJ
Figure 18. Towbar (Raised Position)
31222372
Machine Operation
BM000398A
81