4.16 Shut Down And Park; 4.17 Lifting And Tie Down; Lifting - JLG 1250AJP Operation And Safety Manual

3. Reconnect the drive hubs by inverting the disconnect cap
when towing is complete.

4.16 SHUT DOWN AND PARK

To shut down and park the machine, the procedures are as fol-
lows:
1. Drive machine to a reasonably well protected area.
2. Ensure boom is lowered over rear drive axle.
3. Push in the Emergency Stop at Platform Controls.
4. Push in the Emergency Stop at Ground Controls. Position
Platform/Ground Select switch to center OFF.
5. If necessary, cover Platform Controls to protect instruction
placards, warning decals and operating controls from hostile
environment.
3121170
SECTION 4 - MACHINE OPERATION

4.17 LIFTING AND TIE DOWN

(See Figure 4-10.)

Lifting

1. The weight of the machine is stamped on the serial number
plate. If the plate is missing or illegible, call JLG Industries or
weigh the individual unit to find out the Gross Vehicle
Weight.
2. Place the boom in the stowed position with the turntable
locked.
3. Remove all loose items from the machine.
4. Attach lifting device and equipment only to the designated
lifting points.
5. Properly adjust the rigging to prevent damage to the
machine and so the machine remains level.
4-25